模拟示波器 BS-601
厂家: 日本安罗
尺寸: 162x294x352 mm
重量: 7kg
双踪20MHz示波器采用高亮度示波管
垂直灵敏度 5 mV/DIV
最高扫速 0.2μsec/DIV.
特点：
1) Component Tester
2) Wide bandwidth & high sensitivity
3) Very low power consumption
4) High sensitivity X-Y mode
5) Z axis (intensity modulation)
6) TV VIDEO SYNC Filter
7) High frequency rejection filter in the trigger circuit
8) Front panel electrical trace rotator
9) Regulated power supply circuit for accuracy
COMPONENT TESTER is the special circuit with which a single component or components in or out of actual circuit boardcan be easily tested requiring no power to drive the circuit.
The display shows FAULTS of components, size of a component value, and characteristics of components, and half-deadcomponents under a dynamic test.
SPECIFICATIONS
VERTICAL DEFLECTION
Deflection Factor 5mV to 20V/DIV on 12 ranges in 1-2-5 step with fine control.
Bandwidth DC: DC to 2OMHz(-3dB)
AC: 10Hz to 20MHz(-3dB)
Risetime Less than 17.5nsec
Overshoot Less than 3%
Input Impedance lMΩ shunted by 20pFXXX3pF(Max imput: 600Vp-p or 300V DC + AC peak)
Operating Modes Ch-A, CH-B, DUAL and ADD
Chop Frequency 200kHz approx.
Channel Separation Better than 60dB at 1 kHz
CH-B Polarity CH-B can be inverted
HORIZONTAL DEFLECTION
Frequency Response DC to 1MHz(-3dB)
Input Inpedance 1MΩ shouted by 20pF ± 3pF
Max input Voltage 300V DC + AC peak or 600Vp-p
X-Y Operation X-Y mode is selected by SWEEP TIME/DIV switch
CH-A: Yaxis
CH-B: X axis
Intensity Modulalion Z Axis: TTL Level (3Vp-p - 50V) + bright, -dark.
TIME BASE (时基)
Type Automatic and triggered. In automatic mode, sweep is obtained without input signal.
Sweep Time 0.2μsec to 0.5sec/DIV on 20 ranges in 1-2-5 step with fine control and X-Y
Magnifier X5 at all ranges
Linearity Less than 3%
TRIGGERING (触发)
Sensitivity INT: 1 DIV or more
EXT: 1 Vp-p or more
Source INT, CH-B, LINE or EXT
Triggering Level Positive and Negative, continuously variable level control Pull for AUTO
Range 20Hz to 20MHz or more
Sync AC, HF Rej, TV(each + or -)
At TV Sync TV-H(Line) and TV-V(Frame) sync are switched automatically by SWEEP TIME/DIV switch.
TV-V: 0.5sec/DIV to 0.lmsec/DIV
TV-H: 50ZZZsec/DIV to 0.2ZZZsec/DIV
OTHER SPECIFICATIONS
CRT HV APPROX-2KV
Calibration Voltage 0.5Vp-p ±5%, 1kHz Square Wave
